|
Rudiments
|
Inherits filedescriptor.
Public Member Functions | |
| serialport () | |
| serialport (const serialport &s) | |
| serialport & | operator= (const serialport &s) |
| virtual | ~serialport () |
| bool | setProfileNow (serialportprofile *profile) |
| bool | setProfileOnDrain (serialportprofile *profile) |
| bool | setProfileOnFlush (serialportprofile *profile) |
| bool | getProfile (serialportprofile *profile) |
| bool | drain () |
| bool | flush () |
| bool | flushInput () |
| bool | flushOutput () |
| bool | suspendOutput () |
| bool | restartOutput () |
| bool | transmitStop () |
| bool | transmitStart () |
| bool | sendBreak (int32_t duration) |
The serialport class is similar to the filedescriptor class, but read() returns EOF when a timeout has occurred. This class should be used when communicating over a serial port.
Also, this class wraps some functions from termios.h
| serialport::serialport | ( | ) |
Creates an instance of the serialport class.
| serialport::serialport | ( | const serialport & | s | ) |
Creates an instance of the serialport class that is identical to "s".
| virtual serialport::~serialport | ( | ) | [virtual] |
Deletes this instance of the serialport class.
| bool serialport::drain | ( | ) |
Waits until all output written to the serial port has been transmitted.
| bool serialport::flush | ( | ) |
Discards all output written to the serial port but not yet transmitted and all buffered input.
| bool serialport::flushInput | ( | ) |
Discards all buffered input.
| bool serialport::flushOutput | ( | ) |
Discards all output written to the serial port but not yet transmitted.
| bool serialport::getProfile | ( | serialportprofile * | profile | ) |
Sets "profile" to the current profile of the serial port.
| serialport& serialport::operator= | ( | const serialport & | s | ) |
Makes this instance of the serialport class identical to "s".
| bool serialport::restartOutput | ( | ) |
Restores output operations suspended by a call to suspendOutput().
| bool serialport::sendBreak | ( | int32_t | duration | ) |
If the DTE is communicating asynchronously, then a continuous stream of 0-valued bytes are sent to the DTE. If "duration" is 0 then the stream will be sent for between 0.25 and 0.5 seconds. If "duration" is non-zero then the stream will be sent for an implementation-specific period of time.
If the DTE is communicating synchronously, then this method does nothing and returns true immediately.
| bool serialport::setProfileNow | ( | serialportprofile * | profile | ) |
Sets the profile of the serial port to "profile" immediately.
| bool serialport::setProfileOnDrain | ( | serialportprofile * | profile | ) |
Sets the profile of the serial port to "profile" after all output written to the serial port has been transmitted.
| bool serialport::setProfileOnFlush | ( | serialportprofile * | profile | ) |
Sets the profile of the serial port to "profile" after all output written to the serial port has been transmitted. Also discards all buffered input.
| bool serialport::suspendOutput | ( | ) |
Causes data not yet written not to be written until restartOutput() is called. New writes will block when the output buffer is full.
| bool serialport::transmitStart | ( | ) |
Sends a START character out the serial port, hopefully causing the DTE to resume transmission.
| bool serialport::transmitStop | ( | ) |
Sends a STOP character out the serial port, hopefully causing the DTE cease transmitting data until a START character is sent.
1.7.4